Samson TCM-3 Instruction Manual - Operating Instructions
OPERATING INSTRUCTIONS
1. POWER ON/OFF
By pressing this key(1), the unit is switched on and off.
This unit is turned on by pressing any key.
2. SELECT(SEL)
3. VOLUME KNOB
Rotate Volume up/down knob to control the VOLUME to select other functions, press the
SEL(2) button shortly until the desired functions is shown on the display.
Figure 1 shows how control functions are selected using the SEL button.
Fig. 1 Selection of sound control functions
1. VOLUME 2. SELECT3. BASS 4. TREBLE 5. BALANCE 6.FADER
To increase or decrease the volume by rotating the volume knob. These buttons can be used
to adjust the BASS, TREBLE, BALANCE and FADER.
(1) TA SEEK/TA ALARM (2)
When press the SEL button (2) for more than 2 seconds,it is activated as selecting mode of
these function. TA SEEK Mode or TA ALARM mode is selected by rotating the volume knob.
TA SEEK mode:
When newly turned station does not receive TA infor-mation for 5sec, the radio retunes to
next station which has not the same station(PI) as the last station, but has the TA informa
tion.In TA seek mode,the current station can be changed to the completely different station
because the unit searches TA station when the field strength of the current station is very
weak, or the current station has no TA signal.
-TA ALARM mode:
Any automatic retune mode is not activated, just can be heard Beep sound.
(2)PI MUTE / PI SOUND(2)
When press the SEL button for more than 2 seconds, it is activated as selecting mode of
these function.
(3)RETUNE L/S
When press the SEL button for more than 2 seconds, it is activated as selecting mode of
these function.