Samsung ADC4400TB Owner's Instructions Manual - page 15
E-
15
Removing Excess Humidity
ENGLISH
If the atmosphere in your room is very humid or damp, you can remove
excess humidity without lowering the room temperature too much.
1
To select the DRY mode, press the Mode button until is displayed at
the top of the wired remote controller.
Result:
◆
The air conditioner runs in DRY mode.
2
The air conditioner is fitted with a protection mechanism to prevent the
unit from being damaged when it is started immediately after being:
◆
Plugged in
◆
Stopped
It will start up normally after three minutes.
You can change modes at any time.
If necessary, press
(ON/OFF) button.
Result:
◆
The On/Off indicator on the wired remote controller comes on.
◆
The air conditioner runs in the mode selected when
◆
the unit was last used.
IM
PORTANT
N
N
N
N
o
o
o
o
tt
tt
e
e
e
e
To adjust the temperature, press the Temperature buttons one or more times until the required
temperature is displayed. Possible temperatures are between 18
O
C and 30
O
C inclusive.
Result:
◆
Each time you press Temperature buttons:
- The temperature is adjusted by 1
O
C.
◆
The air conditioner starts removing the excess humidity.
The quantity of air is adjusted automatically.
3
In the dry mode, the fan speed is controlled automatically.
N
N
N
N
o
o
o
o
tt
tt
e
e
e
e
Airing Your Room
If the atmosphere in your room is stale, you can air it using the FAN feature.
If necessary, press
(ON/OFF) button.
Result:
◆
The On/Off indicator on the wired remote controller comes on.
◆
The air conditioner runs in the mode selected when the unit
was last used.
1
Select the fan speed by pressing the Fan button one or more times until
the intended value is displayed:
3
Low
Medium
High
You can change modes at any time.
N
N
N
N
o
o
o
o
tt
tt
e
e
e
e
To select the FAN mode, press the Mode button until is displayed at
the top of the wired remote controller.
Result:
◆
The air conditioner runs in FAN mode.
2