Samsung ADC4400TB Owner's Instructions Manual - page 21
E-
21
Removing Excess Humidity
ENGLISH
To select the DRY mode, press the Mode button until is displayed
at the top of the wireless remote controller.
Result:
◆
The receiver & display unit beeps.
◆
The air conditioner runs in DRY mode.
2
You can change modes at any time.
To adjust the temperature, press the Temperature buttons one or more times until the required
temperature is displayed. Possible temperatures are between 18
O
C and 30
O
C inclusive.
Result:
◆
Each time you press Temperature buttons:
- The temperature is adjusted by 1
O
C.
- The receiver & display unit beeps.
◆
The air conditioner starts removing the excess humidity.
The quantity of air is adjusted automatically.
3
If the atmosphere in your room is very humid or damp, you can remove
excess humidity without lowering the room temperature too much.
1
If necessary, press
(ON/OFF) button.
Result:
◆
The On/Off indicator on the receiver & display unit comes on.
◆
The air conditioner runs in the mode selected when
◆
the unit was last used.
◆
The receiver & display unit beeps.
The air conditioner is fitted with a protection mechanism to
prevent the unit from being damaged when it is started
immediately after being:
◆
Plugged in
◆
Stopped
lt will start up normally after three minutes.
IM
PORTANT
N
N
N
N
o
o
o
o
tt
tt
e
e
e
e
In the dry mode, the fan speed is controlled automatically.
N
N
N
N
o
o
o
o
tt
tt
e
e
e
e
Airing Your Room
If the atmosphere in your room is stale, you can air it using the FAN feature.
Select the fan speed by pressing the Fan button one or more times until
the intended value is displayed:
3
Low
Medium
High
To select the FAN mode, press the Mode button until is displayed at
the top of the wireless remote controller.
Result:
◆
The air conditioner runs in FAN mode.
2
You can change modes at any time.
N
N
N
N
o
o
o
o
tt
tt
e
e
e
e
If necessary, press
(ON/OFF) button.
Result:
◆
The On/Off indicator on the receiver & display unit comes on.
◆
The air conditioner runs in the mode selected when
◆
the unit was last used.
1