Sephra 4oz Popcorn Maker Operating Manual - Using Your Popcorn Maker
9
USING YOUR POPCORN MAKER
It is important that the operator of this appliance should follow the instructions listed below
carefully. Failure to do so may result in damage to your Popcorn Maker.
Before using the Popcorn Maker please ensure that the voltage is suitable for your country.
The voltage should match the rating label specified next to the power cord.
Clean the internal surface of the
Kettle (B), and all the units surfaces, then hook the Kettle (B)
onto the Hanger of the
Main Unit (A).
The
Main Unit (A) has three different switches with three different functions.
1. Switch on the Light (Figure 1) in the
Main Unit (A).
2. Pour 2oz of oil into the
Kettle (B) (Figure 4).
3. Pour 8oz of Popcorn kernels into the
Kettle (B) and close the Kettle (B) Lid (Figure 5).
4. Switch on the Agitator and Heater (Figures 2&3).
5. The Agitator should begin to rotate (Figure 6).
6. Allow the oil to melt then add the correct measure (per instructions) of flavouring.
7. The Popcorn kernels should start to pop within a minute or two.
8. Popcorn will begin to spill out of the
Kettle (B) onto the Heating Deck (Figure 7).
9. Switch off the Agitator and Heater (Figures 2&3) when the popping becomes less frequent.
10. Release the
Kettle (B) from the Latch and pour the remaining Popcorn out of the Kettle
(B) onto the Heating Deck.
11. Serve Popcorn with scoop provided.
12. Remove the plug from the power supply if the unit is not being used for a long time.
13. Repeat the above steps for more Popcorn.
Figure references 1 to 7