Serene S2022 Operating Instructions Manual - Program Set Up:
12
Serene S2022/3
Heating panel
Program set up:
Turning the heater Power ON/OFF
When the unit is connected to power there is a short buzz, the blue power
indictor 8 lights up and the LCD display will light for 12 seconds.
Pressing the’ Power On’ button 1 turns the heater on and the day, time and
room temperature are displayed.
Then select HI or ECO temperature setting 2
Manual or Programmed operation selection 3
Temperature setting
Eco or program mode.
Touch 5 or 6 and the temperature indication will flash.
Touch 5 or 6 again to set the temperature.
To finish temperature setting touch confirm button 4.
When the setting temperature stops flashing the room temperature will
show on the LCD screen.
Time setting
When setting up the program for the first time the actual time needs to be
set up as follows.
Day:
With the power on press 3 and 4 at the same time for 3 seconds.
The day 9 will flash.
Touch 5 and 6 to select the day and press 3 to finish.
Hour:
The hour indicator 17 will be flashing,
Touch (5 or 6) to set the hour and press 3 to finish.
Minute:
The minute indicator 18 will be flashing.
Touch 5 or 6 to set the minute and touch 3 to finish.
Seconds:
19 will be flashing,
Touch 5 or 6 o set the seconds and press 3 to finish.
After setting the seconds the controller will revert back to
the day setting as a cycle.
Touch button 4 to finish time setting.
All time symbols will now stop flashing.