Serene VM-150 Operating manual - To Delete All Messages:
- -
10
5. To repeat the current message, press “REPEAT” once. If you want to go to
the previous message, press “REPEAT” twice.
6. To skip the current message, press “SKIP” and it will play the next
message.
7. To stop the current message temporarily, press “PAUSE” key; the display
will show “PA”. To resume playing, press “PAUSE” again
8. To stop message playback and go back to standby more, press and hold
STOP for 2 seconds.
To Delete All Messages:
Note: This will allow you to delete all old messages only.
1. While in standby, press and hold “DELETE” for 3 seconds.
2. It will then announce “all messages deleted”
3. The digital indicator will display “00” confirming that all messages have
been deleted.
Recording an OGM (Out going message):
The VM-150 comes with 2 factory Out Going Messages (OGM1 & 2).OGM1 is
the default greeting message. OGM 1 is: “
Your call cannot be answered at
the moment, please leave a message after the tone
”.
OGM 2 is: “Your call cannot be answered at the moment, please call again
later”. If this is acceptable to you, you don‟t need to record a new one.
How to choose OGM1 or OGM 2:
If you want to change from OGM 1 to OGM 2 do the following steps:
1. While in standby, press and hold the “ON/OFF” key for 3 seconds.
2. It will announce “Out going message two” (or OGM1 depending which you
have set) and start playing your OGM 2 (1).
3. After it has been played, it will go back to standby.
4. Press “OGM” once to confirm that you have changed your OGM to the one
you want.