Serious RED 52K650Z Operator's Manual - Encore
ENCORE
2
ASSEMBLY INSTRUCTIONS for
42B350Z ; 42K450Z ; 48B450Z ;
48K550Z ; 52B550Z ; 52K650Z.
Remove unit from crate, taking care to re-
move inner boxes and the small parts box.
1. Remove deflector chute, bolt bag and
operator’s manual from main assembly.
2. Open bolt bag and lay out bolts:
(8) – 5/16 X 3/4 HHCS
(2) – 5/16 X 1 HHCS
(2) – 5/16 Nyloc Nuts
(4) – 5/16 Whizlock Nuts
(4) – 5/16 Lock Washers
3. Take the 2 - 5/16 X 1 HHCS and 2 – 5/16
Nyloc nuts and bolt deflector into place.
CRATE REMOVAL INSTRUCTIONS
To remove the mower from the crate, take the
top frame off the mower pallet.
Assemble the unit as instructed by the As-
sembly Instructions.
After fueling and oiling the engine, hook up
the battery.
Before Operating - Reminders
Fill engine crankcase as per engine
manufacturer’s manual. ENGINE DOES
NOT HAVE OIL IN CRANKCASE FROM
THE FACTORY. Add proper fuel to fuel tank,
open value.
The battery is now a gel-cell and will not
require acid.
Before hooking up the ground wires make
sure that the engine has been filled to the
proper level with oil.
If battery will not turn the engine over after
hooking the wires up it may require a charge
for 15 to 20 minutes.
Raise the unit slightly and place a board
under each rear wheel.
With the deck in the raised position start the
unit and drive it off the pallet.
Once you are familiar with the contents of this
manual you are ready to mow with the finest
mower built!
Note: Make sure to
connect both
ground wires.