SERO DS-045 Operation Manuals - Operation Guide
Operation Guide
Press "Mode" button to select the required working mode, which is
changed in the following sequence when pressed once:
Heating mode is available only on cooling-heating type air conditioner.
Automatic operation will be explained in detail on next page.
When Automatic FAN is selected, the air-conditioner will automatically select the suit-
able amount of air flow according to room temperature.
When Dehumidifying is selected, the amount of air flow is set by the machine and fan
setting is not functional.
o
o
Range of adjustable temperature settings : 16 C ~ 31 C.
If it is desired to run the machine at the same settings for mode, air flow and temperature
as the last operation, skip Steps 1~3 and start the machine directly.
If the interval is shorter than 3 minutes from last shut down to the present switch-on, the
compressor only re-starts after 3 minutes to protect the system.
After switching on and if the mode is changed, the system may delay for 3 minutes before
starting operation.
When heating mode is selected, the internal fan will delay operation for a while when the
machine is switched on to prevent cool air circulation at the beginning.
After switching on, air flow amount and temperature may be separately adjusted as desired.
Press "FAN" button to select the required amount of air flow,
which is changed in the following sequence when pressed once :
Press "Temperature Adjustment Button " to set temperature 1
degree higher.
Press "Temperature Adjustment Button " to set temperature 1
degree lower.
Hold down the Button to increase of decrease the temperature
settings progressively.
Press "On/Off" button, and when the unit receives the signal, it gives
out two "beep" tones, the operation light is on and the dehumidi-
fier starts operation.
Automatic
Heating
Automatic
Low
Mid
High
Dehumidifying
Fan
Proper settings of Heating, Dehumidifying and Fan modes
Mode Selection
NOTE:
NOTE:
NOTE:
NOTE:
Air Flow Selection ( 2 )
Temperature Setting Selection ( 3 )
Starting Operation ( 4 )
( 1 )
O
C
COOL
TEMP
AUTO FAN
S W I N G
ON / OFF
MODE
OFF
ON
CANCEL CONFIRM
SWING
SLEEP
FAN
TIMER
HEATER
1
2
3
4
11