Serpent Pool Cleaning System Operating Instructions Manual - page 4
ASSEMBLY INSTRUCTIONS
ASSEMBLY INSTRUCTIONS
Cleaner Body Assembly:
1. Insert both wings into the cleaner body, right into side with R, left into the side
with L. Push the wing in until it slides over the tab.
2. Attach the skirt pad to the bottom lip of the cleaner by sliding it around and
over the lipped circular opening. The pleats should be facing up. The skirt should
spin freely after it is attached.
3. Fit the clear pad over the lipped opening by fitting the lip into the clear
pad’s grove and working the grove over the lip as you go around.
TROUBLESHOOTING TIP: Notice the condition of the clear pad: when the
square ridges are worn down, it is time to replace the clear pad. Also note
the intake area of the cleaner. Debris will need to be periodically cleaned
out using fingers or a small flathead screwdriver.
4. Attach the bumper tail by sliding the bottom into the groove first and then
sliding the top over the tabs on the cleaner’s handle.
5
6