Setec DRIFTER Owner's Manual - page 9
Fresh Water Tanks
These indicate the approximate water level in each of the tanks.
If a tank is not installed that tank indicator will always show empty (no level
segments will be shown).
When full, all level segments are shown.
When empty, the bottom level segment flashes and the other segment are not
shown.
Note: If the pump switch is off, the water level displays are not updated; they
continue to show the levels from the last time the pump switch was on.
Waste Water Tank
This indicates the approximate level in the waste water tank.
If the tank is not installed the indicator will always show empty (no level segments
will be shown).
When full, all level segments are shown and are flashing.
When empty, only the bottom level segment is shown.
Note: If the pump switch is off, the display is not updated; it continues to show the
level from the last time the pump switch was on.
Battery Volts Low
This indicator shows when the battery voltage is at or below 11.0 Volts.
Battery Off
This indicator is displayed when switch is in the up position.
Water Pump Off
This indicator is displayed when the water pump switch is in the off position.
Description of Switches and Buttons
Battery Switch
Note: This Drifter product is designed to interface with the Setec STIII series
power supplies. The functionality described below assumes the Drifter has been
correctly connected such a power supply.
The Battery Switch is used to disconnect the battery from the loads.
In the up position the battery cannot power the loads and “BATTERY OFF” is
9
5
6
7
10
11
12
14
17
17
8
11