SMART-AVI HDR-4x4-Plus User Manual - page 5
5
Figure 5-1
HARDWARE INSTALLATION
1. Turn off all input devices and displays.
2. Connect (4) HDMI cables from the input devices to the INPUT ports of the HDR-4x4-Plus.
3. Connect the displays to the (4) OUTPUT ports on the HDR-4x4-Plus.
4. Power on the input devices, displays, and the HDR-4x4-Plus.
REAR VIEW
FRONT PANEL CONTROL
Button A: Select the input source for HDMI output A
Button B: Select the input source for HDMI output B
Button C: Select the input source for HDMI output C
Button D: Select the input source for HDMI output D
LEDs 1,2,3,4: Shows the input source selected
Act: Shows if the corresponding input signal is active
Link: Shows if the sync device is connected
Button EDID: Select the EDID
+ Auto: Default EDID
+ Manual: User can configure the EDID manually.
+ 2D: 2D-compatible EDID
+ 3D: 3D-compatible EDID