SMART-AVI HDR-8X8-XT User Manual - page 7
7
REAR PANEL
Figure 7-1
1. GND: Connect the Housing to ground.
2. IR Matrix
IR EXT: If the panel sensor is obstructed or the unit is installed in a closed area out of infrared line of
sight, an IR RX receiver (EYE) can be inserted into the IR EXT port at the rear to extend the IR sensor
range and enable local control of the matrix.
(Plug in IR emitters and IR eyes are sold separately)
See the IR CONTROL SYSTEM section of this manual for IR INPUT and IR OUTPUT set up and operation.
3. PC CONTROL
TCP/IP: This port is the link for TCP/IP control, connect to an active Ethernet link with an RJ45 terminated
cable.
4. AUDIO OUTPUT & RS-232: The coaxial and analog audio outputs allow the audio coming into the HDR-
8X8-XT via the HDMI INPUT to be output to stereo speakers or audio amplifiers. The TX and RX for RS232
communication allows you to transmit RS-232 via the corresponding HDBaseT OUTPUT over CAT 5e/6
cables to an HDX-POE-PRO HDBT receiver. For example, you can connect a control PC to the OUTPUT A,
RS-232 connector on the HDR-8X8-XT. Then connect an RS-232 device to the RS-232 connector on the
HDX-POE-PRO HDBT receiver connected to OUTPUT A on the HDR-8X8-XT .
5. HDMI INPUT: Connect to the HDMI input source devices such as a Computer, DVD player or a Set-top
Box with HDMI cables.
6. VIDEO OUTPUT: The HDMI OUTPUT connect to HDMI equipped TVs or monitors and the HDBaseT OUT-
PUT connects to an HDBaseT Receiver such as the HDX-POE-RX. Each of these outputs works with the
corresponding audio and RS-232 outputs in section 4.
7. Ethernet: This slot provides Internet connectivity to the devices connected to the 8 RJ45 OUTPUT ports.
8. AC POWER INPUT: Connect to AC power with AC power cable.