Smart-e SLX-111 User Manual - page 9
Installation and Operation of Receiver
Page 6
1. Connecting SLX-RX111 to the display device
1.1
Making sure that the Cat 5 cable is connected to the SLX-TX111
transmitter output, connect the cable to the RJ45 socket on
the
receiver
unit.
1.2
If the cable connection is correct the power LED on the front of the
receiver should illuminate (power is sent up the Cat 5 cable).
1.3
Connect the display to relevant connector on the receiver
(see diagram below) using the appropriate cable
1.4
If RS232 control is required then connect to the display via the
3.5mm minijack on the receiver using a CAB-J19-1M.
Smart-e (UK) Ltd, Ranmore Manor, Ranmore Common, Dorking, Surrey, RH5 6SX
+44 (0) 1483 283365 Fax: +44 (0) 1483 281511, www.smart-e.co.uk