Smartahome Grand Ultimate 2000 User Manual - Assistance.
12
D2. Toggle the display input to correspond with the video input
you are using. For instance, a TV defaults to the antenna or cable
input when it is turned on. You will see either a TV channel or
snow. Using the remote control toggle the input to display the
VIDEO rather than the antenna/cable. Each TV varies slightly,
so you may need to refer to your TV's user's manual for further
assistance.
D3. If your TV does not have a VIDEO input, you may connect
through a VCR's VIDEO IN. Note: Since virtually every VCR is
different, please refer to your VCR User's Manual for exact
instructions for recording an external video source.
To connect a Grand Vision converter to a VCR for recording,
follow these steps:
1. Using either the RCA or the S-video (recommended) cable, connect
from the video out on the Grand Vision converter to the Video IN on
the VCR
2. Using either an RCA or a 75 Ohm coaxial cable connect from the
Video OUT on the VCR to the Video IN on the TV
3. Set the TV/VCR switch on the VCR to "VCR"
4. Set the TV to display the video input signal (Refer to TV's User's
manual for instruction on displaying an external video source)
5. You should be able to see the converted computer display on the TV
6. Insert a blank tape into the VCR and press "RECORD". Stop the
tape after a few moments to test that it is recording.
SMARTHOME™ 1-800-SMART-HOME 949-221-9200 http://www.smarthome.com Order 7743