SmartBridges airClient Nexus PRO TOTAL Quick Installation Manual - Mounting The Equipment
8
u
n
w
i
r
i
n
g
o
u
r
w
o
r
l
d
™
Mounting the Equipment
The TOTAL unit is shipped with mounting hardware that accommodates tower, mast or
rooftop installations. This section describes the mounting process for each installation. The
unit must be professionally installed. The installer must understand wireless techniques,
antenna alignment, adjustment and grounding techniques.
The TOTAL unit is designed for a quick and simple out-of-the-box installation. Remove the
unit from the shipping box and locate the mounting plate with the M4 HEX bolt and nut.
1. Tower or Pole Mounting
Figure 4- Tower or Pole Mounting
To mount the unit on a tower or pole, follow the steps below:
. Find a suitable mounting location on the tower and hoist the entire assembly to
the selected location.
2. Position the assembly as shown in Figure 4- and attach the mounting plate to
the tower or pole using the 4 supplied M8x75 mm SS bolts, which fit 0.5 to 2.0
inch poles. Use the two sets of washers between the bracket and the nut/bolt
head (see Figure 4-).
Chapter 4 - Mounting
2
2
3