SmartBridges airClient Nexus PRO TOTAL Quick Installation Manual - page 23

Intelligent Wireless Nexus Platform

u

n

w

i

r

i

n

g

o

u

r

w

o

r

l

d

™

9

3.  Loosen the M4 HEX nut and adjust the vertical and horizontal alignment of the  

unit to point towards the remote base station.

2. Wall Mounting 

Follow these steps to wall mount the TOTAL unit using the same wall/pole mounting 

plate:

.  Choose a location on the wall where you are going to install the unit.

2.  Mark the drill hole locations on the wall using the template provided. 

3.  Drill the wall to a depth of 2 inches (50 mm) with a 0.3 inch (8mm) diameter. 

4.  Drive the M8X60 mm Anchor bolt inside each hole and ensure that it is firmly  

fixed to the wall. 

5.  Place the mounting plate over the Anchor bolts already inserted onto the wall  

and secure them with the 4 M8 mm Anchor HEX nuts provided. Use the washer  

between the nut and the bracket (see Figure 4-2).

6.  Loosen the M4 HEX nut and adjust the vertical and horizontal alignment of the  

antenna to point towards the remote base station.

Figure 4-2 Wall Mounting

5

5

6