Smartec STS-IPD160 User Manual - page 4
2
1.2 Preparation before setup
To configure the video Decoder, you have to use the Internet Explorer to
login the video Decoder. Before that, your PC’s networks settings and the
video Decoder’s IP address must be setup. Make sure all the connections
are connected correctly, and then follow the procedures below to setup.
1. Setup your PC network
You have to match your PC’s TCP/IP setting with the video Decoder’s
default settings before you can use IE browser to login it. This section
tells you how to setup your PC’s TCP/IP settings.
2. Setup video Decoder’s IP address
This video Decoder’s IP address can be setup manually or
automatically by network service (DHCP).
1.2.1
Setup your PC network
To set up the network of video Decoder via a PC, you have to change the
TCP/IP settings of the PC.
The following are the default network settings of video Decoder.
IP Address: 192.168.0.200
Subnet Mask: 255.255.255.0
To access the video Decoder, the IP address of the PC should match the
address below.
IP Address: 192.168.0.xxx
Subnet Mask: 255.255.255.0
The procedures below is the setup procedure of a PC using Windows XP as
its OS. When running an OS other than Windows XP, please refer to the
manual included with the OS.
z STEP1
NOTE:
xxx should be a number from 1 to 254, but 200 is excepted.