Smartek ST-X500 Instruction Manual - page 7

Page6

Steam press Instruction Manual

STEP 4 - SELECTING THE TEMPERATURE

a. Turn the Temperature Control Dial (A) until it points to the kind of fabric you wish to press.

b. Examine the garment label if unsure and look up the type on the chart (B) Below:

             Nylon         Silk         Wool           Cotton            Linen

             Acetate                      Polyester     Triacetate

                                               Rayon

IMPORTANT NOTE: If you can not determine the type of fabric, begin with the 

lowest setting and increase the temperature as desired until 

you obtain the proper results.

c. When the Ready Light (C) goes off, the Pressing Plate has reached the temperature 

for the desired setting.

d.

When changing the setting from a higher selection to a lower setting allow several 

minutes for the Pressing Plate to cool sufficiently after making the change.

IMPORTANT NOTE: You may find it more efficient to arrange your fabrics from those requiring the lowest setting to those requiring the highest 

setting and proceed accordingly.  This will avoid any unnecessary delay or wait for the Pressing Plate to cool.