Smarthome 12063W Quick Referenc Manual

Summary of 12063W

  • Page 1

    Keypadlinc tm wall-mounted x10 controller wall-mounted x10 controller with integrated dimmer for models: #12063w & #12064w controller only #12073w & #12074w with dimmer and amber leds #12073wb & #12074wb with dimmer and blue leds #12073ww & #12074ww with dimmer and white leds about keypadlinc’s cert...

  • Page 2

    Hot or line - the wire in the junction box that contains the incoming electricity from the electrical panel. It is usually black and may be tied with a wire nut to other black wires in the rear of the box. Load- the wire in the junction box that goes to the light(s). Usually, there is just one load ...

  • Page 3

    Quick reference guide use these quick start instructions to make a change to an existing keypadlinc or after you have read through the detailed programming instructions beginning on page 6. These instructions show the basic steps for the most common programming functions without all the explanations...

  • Page 4

    Use a keypadlinc with an integrated dimmer to install in place of an existing mechanical switch. You can also use a transmit-only keypadlinc, but you’ll need a fixture relay module (#2250/ 2251) to control the load. 21 21 problem keypad does not take programming signals & exits the setup mode. Signa...

  • Page 5

    Helpful tools if you’re investing in home automation, there are a few tools that will make your projects run smoother: invest in a maxi-controller this plug-in transmitter has the ability to send individual x10 commands. The buttons are separated into addresses and command functions. To use this con...

  • Page 6

    Xx 19 setting it up the keypadlinc does not use code wheels or dials to set programming addresses. Instead, it accepts the first address on the powerline once the programming mode is started. Any plc/x10 transmitter can be used to set the primary address. The settings are stored in non-volatile memo...

  • Page 7

    Xx 18 assigning a button to the integrated dimmer (optional) once the integrated dimmer has been assigned a primary address, it needs to be assigned to one or two of the control buttons on the keypadlinc. 1. Push and hold any 2 buttons for at least 5 seconds. When all of the lights under the buttons...

  • Page 8

    Xx 17 integrated dimmer’s advanced primary address programming the integrated dimmer’s ramp-rate and default on-level can be remotely set using an x10 maxi-controller (smarthome #4020) or an equivalent transmitter capable of sending housecode and unit code without on or off. These procedures and all...

  • Page 9

    Factory reset if keypadlinc begins to operate strangely, the factory reset procedure can be used to clear the eeprom’s memory. 1. Gently pull the set button out to remove power for 5 seconds. 2. Push and hold in the set button for 5 seconds, then release. 3. When the led indicator comes on, the keyp...

  • Page 10

    Setting up groups buttons can be programmed in groups, which allow the indicator lights under the button to be illuminated when the button is pressed. When another button in that group is pressed, the keypadlinc sends the programmed signal, turns off the light of the previous button and turns on the...

  • Page 11

    Selecting the button’s modes: toggled or non-toggled the buttons on the pad can be programmed in one of two ways: toggled mode in this mode, the keypad can send two different commands on alternate presses. For example, pressing a button when the indicator light is off will cause an on signal to be s...

  • Page 12

    Toggle mode button programming: in this step, it is necessary to send two x10 signals to the keypad from an x10 transmitter. The first transmission will contain an x10 address; the second will contain information on how the button is to behave. 1. Enter the setup mode (by holding any two buttons for...