Smarthome X10 Owner's manual - page 3
Page 3 of 6 X10LM465 Rev: 12/6/2011 5:39 PM
About X10 Lamp Dimmer
This advanced remote-controllable plug-in module allows you to add X10 control to your lamps and
create customized lighting. Simply plug X10 Lamp Dimmer into a wall outlet and connect the desired
lamp. Program an X10 address to X10 Lamp Dimmer in seconds and you'll be able to use an X10
controller to turn the connected device on, off, dim and bright.
Status LED
Set button
Outlet
Features & Benefits
Fully X10 compatible to receive commands from any X10 controller
Controls all standard incandescent loads up to 150 Watts
Programs in less than a minute
Super quiet operation
90-day
warranty
What’s in the Box?
X10 Lamp Dimmer
Quick-Start Guide
Getting Started
CAUTIONS AND WARNINGS
Read and understand these instructions before installing and retain them for future reference.
This product is intended for installation in accordance with the National Electric Code and local regulations in the United States or
the Canadian Electrical Code and local regulations in Canada. Use indoors only. This product is not designed or approved for
use on power lines other than 120V 60Hz, single phase. Attempting to use this product on non-approved power lines may have
hazardous consequences.
-
Use only indoors or in outdoor rated box
-
To reduce the risk of overheating and possible damage to other equipment, do not use this product to control loads in
excess of the specified maximum(s) or, install in locations with electricity specifications which are outside of the product’s
specifications. If this device supports dimming, please note that dimming an inductive load, such as a fan or transformer,
could cause damage to the dimmer, the load bearing device, or both. If the manufacturer of the load device does not
recommend dimming, use a non-dimming on/off switch. USER ASSUMES ALL RISKS ASSOCIATED WITH DIMMING AN
INDUCTIVE LOAD.