Smarthome X10 Owner's manual - page 4
1) Plug the lamp or device (also called the load) you want to control into the outlet on the bottom of X10
Lamp Dimmer
2) Plug X10 Lamp Dimmer into an unswitched outlet
X10 Lamp Dimmer’s LED and the load will turn on
Setting the X10 Address
1) Press & hold X10 Lamp Dimmer’s Set button until its LED is blinking
2) Using an X10 controller, send the X10 address you want to assign followed by the ON command
three times.
For example, to assign the address A1, send “A1 ON A1 ON A1 ON”.
X10 Lamp Dimmer’s LED will flash twice and turn on solid
Removing the X10 Address
1) Press & hold X10 Lamp Dimmer’s Set button until its LED is blinking
X10 Lamp Dimmer’s LED will begin blinking
2) Press & hold X10 Lamp Dimmer’s Set button for 3 seconds
X10 Lamp Dimmer’s LED will continue blinking
3) Using an X10 controller, send the X10 address you want to remove followed by the ON command
three times.
For example, to remove the address A1, send “A1 ON A1 ON A1 ON”.
X10 Lamp Dimmer’s LED will flash twice and turn on solid
Advanced Features
Setting the On-Level
On-Level is the brightness that the light you are controlling will go to when you turn it on. The On-Level is
adjustable from off to 100% brightness.
Default: 100%
1) Use an X10 controller to adjust the load to the desired brightness
2) Tap X10 Lamp Dimmer’s Set button
The load will flash once
Factory Reset
1) Unplug X10 Lamp Dimmer for about 10 seconds
2) While holding down the Set button on X10 Lamp Dimmer, plug the unit back in, making sure not to let
go of the Set button
3) Once X10 Lamp Dimmer is plugged in, continue to hold down the Set button for 3 seconds, then
release
X10 Lamp Dimmer’s LED will flash once. Within a few seconds, the LED will turn on solid and the
load will turn on
Page 4 of 6 X10LM465 Rev: 12/6/2011 5:39 PM