SmartMat Mat 100W Installation Manual - Mat Planning Examples
6
Mat Planning Examples
100 watt/150 watt/200 watt
Please follow these instructions
carefully. If you require assistance
prior to or during your installation
please call our helpline on
01473 559077.
Layout of second mat
Layout of first mat
Plan using two mats
Plan using one mat
Planning your mat
When planning your SmartMat,
ensure you cover as much of your free
floor area as possible:
• never install your heating cables any
less than 50mm apart.
• never cut your heating cable.
• never remove any pre-manufactured
cable joints or end seal joints.
When installing two or more mats
within the same area always ensure
the cold tail (power cables) are
returned to the thermostat power
connection and are wired in parallel,
never wire your SmartMat in series,
and always check your SmartMat
is thoroughly adhered to the floor
before tiling.
Timber substrates should be prepared
as required by tiling guide lines, for
example bracing of a timber floor with
WBP or tile backer board.
Note
• Sketch your floor plan using the
grid on pages 10 & 11
• Calculate your Total Load on
page 9