Smartpond DP700UV Instructions manual - page 5
5
10. Clean the pump housing where the UV assembly resides insuring
that no debris remains. Fig. 12
Fig. 12
11. Remove the impeller cover to expose the impeller assembly.
Remove the impeller assembly by gently pulling on the impeller
blades. Use a soft cloth or brush to clean the impeller assembly
and inside of the impeller housing. Fig. 13
Fig. 13
12. Reassemble all of the components. Fig. 14
Fig. 14
CARE AND MAINTENANCE
• Clean the pump regularly depending upon the environment in which it is operated. Clean the pump
when it is visibly soiled or when a drop in performance is detected.
• Before cleaning, always disconnect the pump from the power source.
• Remove all parts from the pump and clean in warm, soapy water.
TROUBLESHOOTING
If the pump fails to operate:
• Check to make sure the power cord is plugged in, the pump is getting power and the pump is
fully submerged.
• Check the pump outlet and any tubing, fountains, spitters etc. for kinks or obstructions.
• Remove the inlet screen and/or pump cover, and impeller housing to expose the impeller. Turn
the impeller to ensure that it is not broken or jammed.
If the performance of the pump is not satisfactory or the pump does not flow evenly:
• Check to make sure the pump is completely submerged in water.
• Check to make sure the impeller, filter pad and the housing are clean clear of debris.
• Check the pump outlet and any tubing, fountains, spitters etc. for kinks or obstructions.
• Adjust flow control.
Clean with soap
Impeller cover
Impeller
assembly