Smartswitch FC-006 Installation Manual - page 4
4
Oil Pressure Switch Input Setup:
NOTE: Where indicated the Link wire MUST be installed
Emergency Stop Input Switch:
The Emergency Stop input switch needs to be a normally
closed switch going open when activated.
Emergency Stop
Switch Input
Switch
Oil Pressure
Switch
Switch
Link
Setup for clean contacts.
Note: The Link could also be a relay contact from
an engine running signal. In which case the oil
pressure input will only be looked at if the engine
is running.
1
2
3
4
Oil Pressure
Switch
Input
Link
Setup for input switching to + VDC input.
Note: The Input terminal could be
connected to the ignition switch instead of
using the oil pressure switch for engine
running signal.
1
2
3
4
Oil Pressure
Switch
Input
Link
Setup for input switching to GND.
1
2
3
4