Sprite Electronics SAM-6500D Owner's Manual - Fcc Information
FCC INFORMATION
FCC Part 15 :
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy andm if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a paticular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the eqipment off and on, the user is encouraged to try to correct the interference
by one more of the following measures:
-. Reorient or relocate the receiving antenna.
-. Increase the separation between the equipment and receiver.
-. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-. Consult the dealer or an experienced radio/TV technician for help.
WARNING :
Changes or modifications not expressly approved by the manufacturer could void the user's authority to
operate the equipment.
"NOTE :
The manufacturer is not responsible for any Radio or TV interference caused by unauthorized modifications
could void the user's authority to operate the equipment."
1 YEAR LIMITED WARRANTY
Sprite Electronics USA Inc. will repair this product with new or refurbished parts, free of charge, in the event
of a defect in the material or workmanship.
Carry-in or mail-in service can be obtained during the warranty period from Sprite Electronics USA Inc. or
from any other authorized Sprite Electronics USA Inc. reseller where they were purchased.
This warranty is extended only to the original purchaser. A purchaser receipt or other proof of date of original
purchase will be required before warranty performance is rendered.
This warranty only covers failures due to defects in materials or workmanship which occur during normal use.
Sprite Electronics USA Inc. obligation under this warranty does not apply to any defect, malfunction or failure
as a result of accident, misuse, abuse, neglect, mishandling, misapplication, alteration, modification, lightning,
line power surge, introduction of sand, dust, humidity and liquids or commercial use of the product, service by
anyone other then Sprite Electronics USA Inc. Or any other Sprite authorized Service Center, or damages that
is attributable to acts of God.
Under the terms of this warranty the original consumer purchaser has certain legal rights and may have other
rights which vary worldwide.
-. Information in this document is subject to change without notice and does not represent a commitment on
the Part of Sprite Electronics USA Inc.
-. All other products are trademarks or registered trademarks of their respective holders.