SPRT SP-POS58III User Manual - page 13
SPRT
12
ESC DC4 Cancel Double Width Character Print
Format: ASCII: ESC DC4
Decimal:
27
20
Hexadecimal: 1B
14
Explanation:
After carrying out this command, the characters will be printed in normal
width.
ESC % Select/Cancel User-defined Characters
Format: ASCII: ESC
%
n
Decimal: 27
37 n
Hexadecimal: 1B 25 n
Explanation:
When n=1, select user-defined character set; When n=0, select internal
character set.
Default n=0
ESC & Define User-defined Characters
Format: ASCII
:
ESC & s n m [a [p]s×a]m-n+1
Decimal: 27 38 s n m [a [p]s×a]m-n+1
Hexadecimal: 1B 26 s n m [a [p]s×a]m-n+1
Explanation:
ESC & is used to define user-defined characters. s=3
,
32
≤
n
≤
m
≤
126,
0
≤
a
≤
12, 0
≤
p
≤
255.
◆
s is the number of bytes in vertical direction, s=3 here.
◆
n is the starting ASCII code of user-defined character.
◆
m is the stopping ASCII code of user-defined character.
When define only one character, n=m, the maximum number of
user-defined characters is 96.
◆
a is the number of dots in horizontal direction.
◆
p is the data of self-defined characters, there are s×a bytes for each
character, the total number of user-defined characters is m-n+1.
◆
User-defined characters are valid until re-defined, reset or power off,
format of the user-defined characters is shown as follows: