Spypen QX-O User Manual - page 5
5
• Charging the Battery
The Li-polymer rechargeable battery is integrated in the camera and it is not replaceable. When the LCD
display flashes for about 30 seconds and then the camera turns off automatically, it means the battery is
low. Please follow the following steps to recharge the battery.
NOTE:
Please install the software provided before you connect the camera to your computer. Please refer to “5 Installing the
Software onto a Computer” on page 8 for further details.
USB Series “A” Plug Connects to your Computer
Status LED
1. Plug the camera into the Docking station.
2. Plug the USB cable on the Docking station into the port marked
on your computer.
3. The battery begins charging. The status LED turns green until the charging is completed.
It takes approximately eight hours to fully charge the internal battery the first time after purchase and
then approximately 2 to 3 hours for subsequent recharging depending on use. The battery should last for
thousands of uses but should it ever need to be replaced please visit us at http://www.spypen.com for
information on replacement.
• Turning the Camera On and Off
Press and hold the Mode button until a beep sounds. Release the mode button
and the LCD display is activated. To turn off the camera, press the Mode
button repeatedly till you see “
” on the LCD display, then press the Shutter
button, and the camera will be off.
Mode button
Shutter button
• Automatic Power Saving
This camera is designed to automatically power off to save battery life in 30 seconds of inactivity. Repeat
the above steps of turning the camera on to turn on the camera again.