Congratulations on your purchase of the ssl lopro10, amplified under seat subwoofer. It has been designed, engineered and manufactured to bring you the highest level of performance and quality, and will afford you years of listening pleasure. Thank you for making a ssl your choice for car audio ente...
Introduction the lopro10, introduces a low-profile active subwoofer, its low enough to easily fit under the seat of your car. This system offers you a quick and easy way to add a high-powered subwoofer to your audio system. Both high-level (speaker level) and low-level (rca) inputs are present, maki...
What is included? When first unpacking your new amplified system, please check that the package contains all of the items below. If something is missing, please contact our tech dept. Main unit lopro10 amplified system accessories subwoofer remote control w/ cable high-level input harness mounting h...
Front panel controls and features ① led status indicator blue – on red –protection ② sub phase the sub phase can be used to adjust for bass response. Each vehicle will be different and should be set for your particular installation. If the bass response “disappears”, flipping the switch should fix a...
Rear panel controls and features ① high-level (speaker level) inputs if your source unit does not have rca pre-amp outputs, you can use the speake r outputs to the lopro10. Use the supplied harness and connect the outputs as shown in the connection diagram in this manual. ② rca inputs (low level) if...
Rca inputs (low level) rca cables are preferred for best audio performance. Installation lengths will vary due to sizes. Always connect with the high-quality cables to avoid any induced noise. Note: do not use/connect both high-level and rca inputs at the same time speaker input (high-level) the hig...
Power input connections connect the ground terminal to the closest point on the chassis of the vehicle. Keep this ground wire to less than 3 ft. (36”) in length. Use a high quality ofc 8 gauge wire. Connect the remote terminal to the remote output of the head unit to “rem” using 16 gauge wire. Conne...
Mounting the subwoofer 1. Find a suitable location in the vehicle in which to mount the amplifier. An optional location is shown below: 2. Make sure there is sufficient air circulation around the intended mounting location. 3. The mounting feet have multiple mounting locations. 4. Before drilling an...
Troubleshooting if you experience operation or performance problems with this product, compare your installation with the electrical wiring diagrams on the previous pages. If problems persist, read the following troubleshooting guide which may help. If you have any further questions, please give our...
Specifications maximum power 1200 w thd s/n ratio >88db frequency response 15 hz - 150 hz input sensitivity 200 mv - 6 v low pass filter 50 hz – 150 hz @ 12db/oct subsonic fil ter 20 hz – 50 hz @ 6db/oct bass b o o s t @ 45 hz 0 to +12 db fu se r a ti n g 25 a dimensions 13-7/8” x 11-3/16” x 3” (353...
