Ssl LOPRO10 User Manual - page 5
Rear Panel Controls and Features
① HIGH-LEVEL (Speaker Level) INPUTS
If your source unit does not have RCA Pre-Amp Outputs, you can use the speake
r
outputs to the
LoPro10.
Use the supplied harness and connect the outputs as shown in the connection diagram in this manual.
② RCA INPUTS (Low Level)
If the pre-amp of the source unit is not Full-Range, the speaker level input should be used.
The +12V wire should be fused (25 A) within 18” of the battery, keep away from any signal and/or
speaker lines to avoid noise in the system.
Remote turn-on wire should be coming from the source unit, so the amplifier turns on/off with the
source.
Use the supplied harness and connect the outputs as shown in the connection diagram in this manual.
③ FUSE
Fuse rating is a total of 25 A, always replace the fuse with the same type and value.
④POWER TERMINALS
SSL recommends the use of high quality 8 gauge wiring. The ground should be kept under 3ft (36”).
Always scrape away any paint for the ground connection. Ground point should be clean with the correct
type of bolt to secure it.
The +12V wire should be fused (25 A) within 18” of the battery, keep away from any signal and/or
speaker lines to avoid noise in the system.
Remote turn-on wire should be coming from the source unit, so the amplifier turns on/off with the
source.