SSV Works SS-FKP652 Installation Manual - page 2
B. Place the speaker into the enclosure and mark the 4 mounting
holes with a scribe or marker, Pre-drill the marked mounting
locations using a 1/8” drill.
B. If using a coaxial speaker, connect and install the speaker into the enclosure using the #2
Phillips screwdriver (be sure to connect the “+” speaker wire to the “+” terminal on the speaker
and the “-“ speaker wire to the “-“ terminal on the speaker), then install the triangle block off
plate using the
16mm (smaller)
screws, repeat for other side.
SS-FKP652
B
C
C
A. Drill a 1/4” hole in the enclosure for the speaker wire to run
out of, we recommend the flat side under the logo, toward the
top of the enclosure.
A
D. If mounting a component tweeter, mount the tweeter into the tweeter mounting plate using the
16mm (smaller)
screws, install into the enclosure, then connect and install the speaker into the
enclosure using the #2 Phillips screwdriver (be sure to connect the “+” speaker wire to the “+” terminal
on the speaker and the “-“ speaker wire to the “-“ terminal on the speaker), repeat for other side.
D
D