Suunto EON STEEL 1.2 Quick Manual
1. GET STARTED
2. CUSTOMIZE
1.
4. SET DIVE GAS(ES)
3. SET DIVE SETTINGS
3. After customizing your device, disconnect
the USB cable.
2. Download and install DM5 software.
1. Connect your device.
1. Keep middle button pressed to access menu.
3. Select the gas according to your dive plan.
Select Edit if your mix is not in the list.
1. Keep middle button pressed to access menu.
3.
When settings are ready, keep middle button
pressed to go back and exit.
2. Scroll with upper or lower button to Dive
settings and select with middle button.
5. PAIR SUUNTO TANK POD
General
2. Scroll with upper or lower button to
Gas and select with middle button.
1.
Wake up the device by connecting the
USB cable.
2. Follow the start up wizard to set up
the device. When ready, the device
goes to Surface mode.
PARTS
(1) Suunto EON Steel
(2) Protective boot
(3) USB cable
(4) Bungee adapter
(1)
(4)
(2)
(3)
3. Fully charge before first dive.
19:36
depth, m
dive time
0
0’
Air
www.movescount.com/dm5
synchronizing
DO NOT DISCONNECT
NOTE:
Do not disconnect cable while syncing.
1.
Install Tank POD and open tank valve.
2. Wait for green LED on Tank POD to flash.
5. Select the gas for the Tank POD.
19:36
depth, m
dive time
0
0’
Air
19:36
depth, m
dive time
0
0’
Air
2s
Dive settings
19:36
depth, m
dive time
0
0’
Air
2s
General
Gases
Air
Air
19:36
depth, m
dive time
0
0’
Air
2s
NOTE:
Buttons are locked while cable is connected.
WARNING:
The battery level indication
shown when pairing the Tank
POD is an approximation only.
The POD battery may deplete
faster than the indication
suggests.
3. If your EON Steel has a blank screen, press
any button to activate it.
4. Hold your device close to the Tank POD
as shown.
NOTE:
In CCR mode, you can
set both OC and CC
gases.