Suzuki 2010 Kizashi Owner's Manual - page 273

5-94

OTHER CONTROLS AND EQUIPMENT

57L20-03E

any garage door opener position manufac-

tured before April 1, 1982). A garage door

that cannot detect an object – signaling the

door to stop and reverse – does not meet

current U.S. federal safety standards. For

more information, contact HomeLink

®

 at

www.homelink.com or by calling 1-800-

355-3515.

Retain the original transmitter of the RF

device you are programming for use in

other vehicles as well as for future

HomeLink

®

 programming. It is also sug-

gested that upon the sale of the vehicle,

the programmed HomeLink

®

 buttons be

erased for security purposes. Refer to

“Programming HomeLink

®

” (step 1) only)

or, for assistance, contact HomeLink

®

 at

www.homelink.com or by calling 1-800-

355-3515.

Programming HomeLink

®

NOTE:

Some vehicles may require the ignition

switch to be turned to the second (or

“accessories”) position or the “on” position

for programming and/or operation of

HomeLink

®

. It is also recommended that a

new battery be placed in the hand-held

transmitter of the device being pro-

grammed to HomeLink

®

 for quicker train-

ing and accurate transmission of the

radiofrequency signal. Do not repeat “Pro-

gramming HomeLink

®

” – step 1) to train

additional devices to a second or third

HomeLink

®

 button. Begin with “Program-

ming HomeLink

®

” – step 2).

57L51036

1) Press and hold the two outer

HomeLink

®

 buttons (buttons one and

three) – releasing only when the indica-

tor light begins to flash (after 20 sec-

onds). Do not hold the buttons for

longer than 30 seconds and do not

repeat step 1) to program a second

and/or third hand-held transmitter to the

remaining two HomeLink

®

 buttons.

2) Position the end of your hand-held

transmitter 5–14 cm (1–3 inches) away

from the HomeLink

®

 button you wish to

program while keeping the indicator

light in view.

3) Simultaneously press and hold both the

chosen HomeLink

®

 and hand-held

transmitter buttons. Do not release the

buttons until step 4) has been com-

pleted.

NOTE:

Some gate operators and garage door

openers may require you to replace this

Programming step 3) with procedures

noted in the “Gate Operator / Canadian

Programming” section.

4) After the HomeLink

®

 indicator light

changes from a slow to a rapidly blink-

ing light, release both the HomeLink

®

and hand-held transmitter buttons.

NOTE:

If the HomeLink

®

 indicator light does not

change to a rapidly blinking light, contact

HomeLink

®

 at www.homelink.com or call

1-800-355-3515 for assistance.

5) Press and hold the just-trained

HomeLink

®

 button and observe the

indicator light.

– If the indicator light stays on con-

stantly, programming is complete and

your device should activate when the

HomeLink

®

 button is pressed and

released.

NOTE:

To program the remaining two HomeLink

®

buttons, begin with “Programming

HomeLink

®

” – step 2). Do not repeat step

1).

– If the indicator light blinks rapidly for

two seconds and then turns to a con-

stant light continue with “Programming