SVAT GX301 Instruction manual - Gx301
GX301
29
SVAT ELECTRONICS
now you can see
No Picture/Signal
• Make sure all the connections are secure and properly connected
• Make sure your monitor is plugged into a power source from the
9VDC input on the back
• Make sure there is nothing obstructing the view of the camera
• Try re-pairing the camera and monitor
Picture too Bright/Dark
• The night vision comes on automatically when the light levels drop;
try the camera in a pitch black setting. The area that the camera is in
may get too much light to activate the sensor
• Try adjusting the brightness settings on your monitor
No Audio
• Make sure nothing is interfering with the microphone on
the camera
• Make sure whatever you are trying to hear is close enough to the
microphone on the camera (within 6ft)
• Disconnect and reconnect the wires from the camera and the moni-
tor to make sure they are secure
• Try re-pairing the camera and monitor
• Try adjusting the volume on the monitor that the monitor is
plugged into
• Ensure that the camera volume is turned up using the remote
• Ensure that the AV cord is connected to the proper connections on
the monitor and on the monitor that the monitor is connected to
Buttons are not working
• The buttons do not work in quad screen mode, ensure you are
viewing full screen
• Make sure the button lock function (on the front of the monitor) is
not switched on
Devices are not pairing
• Ensure that the camera and monitor are within 100ft of each other.
• Try moving the devices closer together, sometimes walls/other
obstructions can get in the way of the camera and monitor’s signal
• Ensure that both devices are connected to a proper power source
Night Vision not Working
• The night vision comes on automatically when the light levels drop;
try the camera in a pitch black setting. The area that the camera is in
may get too much light to activate the sensor
Monitor is reading “No Signal”
• Try re-pairing the camera and monitor
• Make sure there is nothing obstructing the view of the camera
• Make sure the camera and monitor are within 100 ft from one
another
Footage not recording
• Adjust what recording setting you are set to
• Make sure SD card is completely in the monitor
• Make sure SD card is not full and that overwrite function is
turned on
• Make sure SD card is not locked by adjusting the tab on the side of
the card
Remote not working
• Ensure that the remote control has batteries inserted into it and that
those batteries are not dead
• Try plugging the IR sensor in
• Try using the remote control closer to the monitor