Sven DRIFT Operation Manual - Eng
7. CONNECTION AND INSTALLATION
• Install the device on even surface (for example,
on a table) on its 5 suction cups. If necessary
fasten it with the ԛxation stand (Fig. 2).
• Connect pedal unit to the device (Fig. 4) via cable
of the pedal unit to RJ-11 jack m, then connect
USB cable n
of the device to the USB port of the
computer.
• Insert Software CD disk into the disk drive of your
PC and launch setup.exe to install drivers on your
PC. There should automatically appear Game Con-
troller window on Desktop of your PC (Fig. 5). Also,
there will open up icon LS-USBMX 1 2 3 Steerin...
(Fig. 6) which is convenient for further adjustments.
• Press Test (Fig. 5), and on the display of your PC
there will appear LS-USBMX 1/2/3 Steering
window (Fig. 7). Here you can make main settings
of axes and buttons.
• Choose Controllers to set axes and buttons (Fig. 8).
Setting of axes and buttons (not compatible
with OS Vista 64)
• Dead Zone setup: controller will not respond to a
slight touch of acceleration pedal (Accelerate Y+),
or brake pedal (Brake Y-), or turns of the wheel
(Steering X), therefore necessary adjustments
should be made by cursors (Fig. 8);
• Sensitivity setup: the higher sensitivity is, the
swifter and more eԝcient response of controller to
pressing of pedals and turns of the wheel will be,
therefore necessary adjustments within Lower to
Higher range should be made by cursors (Fig. 8);
• KeyMap Setup reprograms functional keys: there
should be chosen new necessary assignment
against the key designation (Fig. 8);
• After installation of the driver, the controller can
be automatically centered by pressing MODE
button k.
ATTENTION! During automatic calibration do
not press any buttons.
Fig. 6
Fig. 5
Fig. 7
ENG
4