Sven Driver Operation Manual - Eng
7. CONNECTION AND INSTALLATION
• Install the device on an even surface (for
example, on a table) on its suction caps. If
necessary fasten it with the two fixation stands
(Fig. 6).
• Connect the pedal unit to the device (Fig. 5)
via the pedal unit cable to RJ-11 jack r, then
connect USB cable t of the device to the
available USB port of the computer.
• Insert the Software CD disk into the disk
drive of your PC and launch setup.exe to
install drivers on your PC. Go to the game
controller settings in the control panel and
Game Controllers window should appear on
the your PC (Fig. 7).
Wheel Test
• Axes Test. Pass to the “Test Page” bookmark
(see Fig. 8), rotate the wheel from left to right
and make sure that the X-axis (“+” cross-
cursor) in the “Axes Information” window
moves from left to right correctly. If the cross
cursor is not at the center of the window,
please enter “Calibration Page” to calibrate it.
• Button Test. Press the wheel buttons to see
if button 1 to 12 in the “Test Page” turns red for
each button action (see Fig. 8).
• D-PAD Test. Press each direction of the D-
PAD (UP, DOWN, RIGHT, LEFT and 45 degree
for each direction) to see if the cursor in
«Povinfo» is moving correctly (see Fig. 8).
• Wheel calibration. This option is only used
for calibrating wheel centering fault under
analog mode (the indicator LED turns red):
when the cross cursor is not centered in the
X/Y Axis as seen in the interface, please press
“Default” and then press “Set” (Fig. 9).
• Motors test. Enter “Effect Page” (see Fig. 10)
to test motors. Rotate the wheel and check if
the left motor vibrates. Press the left wing and
right wing d and check if the right motor vibrates. Vibration feedback force can be changed by
moving the cursor to the right or the left along the “RumbleIntensity” line (fig.10).
• Driver Uninstall (reinstall). Restart the driver installer. Click “No” to remove the driver. Click “Yes” to
reinstall the driver (see Fig. 11).
Fig. 7
Fig. 8
ENG
5