Sven Driver Operation Manual - Eng
• Program Setup (no programming function under NEGCON Mode). Enter “Test Page” (see Fig. 8),
press button 9 and button 10 n at the same time. Hold for 3 seconds until program LED turns green.
Press the programmable button. Program LED starts blinking. Press program source button. Program
LED turns off. Program is set.
• Clear Single Program. Press button 9 and button 10 at the same time. Hold for 3 seconds and
program LED turns green. Press programmable button. Program LED starts blinking. Press program-
mable button again. Program LED turns off. Single program is cleared.
• Clear All Programs. Press button 9 and button 10 at the same time. Hold for 3 second until
program LED turns green. Release the buttons. Press button 10 and hold for 4 seconds. Program
LED turns off. All programmed buttons are cleared. Default is restored.
Wheel Sensitivity Adjustment (3 levels):
• Wheel sensitivity can be adjusted by a toggle switch Sensitivity q. There are 3 optional sen-
sitivities: “LO”, “MID”, “HI”.
• By using switch Sensitivity q can be set three levels of sensitivity steering in position “LO” for the
full twist “wheels” to turn the steering wheel to lock, i.e., all 135 degrees. In the position “MID”
enough to turn the rudder to 2/3 speed, and in position “HI” maximum position is reached at the
third steering.
Mode Button Function:
• The game racing wheel has two operation modes: digital and analog.
In the digital mode the static maximum activation/deactivation of corresponding axes take place
during depressing the pedal, i.e. there is only “ON/OFF” position there. In the analog mode a signal is
transmitted depending on the pressure force of pedals, i.e. smoothly. The mode of buttons will not
2. Push the left direction button on the digital
block.
2. Press the DOWN button on the digital block.
For switching to the
digital mode:
1. Press Select + Start (9+10) buttons and hold
them down within 3 seconds, the Mode
indicator will light green. Then release keys 9
and 10.
For switching to the
analog mode:
1. Press Select + Start (9+10) buttons and hold
them down within 3 seconds, the Mode
indicator will light green. Then release keys 9
and 10.
ENG
7