Sven X-PAD AERO Operation Manual - Eng
ENG
5
• Click Function Test (Fig. 6) to test axes and buttons.
• Enter Calibration Function (Fig. 7) to calibrate all
four axes.
• Enter Vibration test (Fig. 8) to test and to set Vibra-
tion feedback function:
a) increase or reduce Vibration strength by moving
cursor. For example: vibration strength is 85% in Fig. 8.
b) test Vibration feedback function on the left or/and
right motors by pressing Left force, Both force and
Right force;
c) after setting and testing press ОК (confirm) in the
bottom of the window.
Note. Vibration feedback function is switched
ON/OFF by VIBRATION ON/OFF switch o.
• Switching Modes.
The device works in Digital Mode and Analog Mode
that are switched by MODE button d, LED color h
changes from red to green according to the selected
Mode. Digital Mode (green LED) has 2 axes and 10
buttons available, while Analog Mode (red LED) has all
four axes and 12 buttons available.
• TURBO function.
Turbo function imitates multiple pressing and holding of any button, while it was pressed only once.
To activate this function, press any button 1-12, hold it and press TURBO button c. Now this
button will be programmed with Turbo function. To cancel this function, press button programmed
with TURBO, hold it and press TURBO button again.
• Sleep mode.
In case the device has not been used for a period of time, it enters Sleep mode to prolong battery
life. If Nano receiver has not been connected for more than 15 se- conds or there have been no
operations carried out with buttons or axes for more than 3 minutes, the device automatically gets
into Sleep mode. To turn on Sleep mode, press one of these three buttons: 10, 11 or 12.
• Low voltage alert function. When battery is weak or empty, the green LED and the red LED will
simultaneously flash indicating that present batteries should be replaced or rechargeable batteries
should be recharged. To prolong battery life, the Vibration Feedback function turns off auto-
matically.
Fig. 8