Summary of CLIP ON PAC-2G3
Page 1
Svp broadcast microwave user’s guide clip on power amplifier pac-2g3.
Page 2
1 pac-2g3 clip-on power amplifier user’s manual dear customer, we would like to thank you for choosing this equipment and welcome you to the svp’s products user’s growing family. We are sure that the addition of this equipment to your existing installation will cause you nothing but satisfaction. Pl...
Page 3: Important Notes
2 pac-2g3 clip-on power amplifier user’s manual important notes 1. Read the instructions carefully before connecting the power amplifier. 2. Use the amplifier together with an omnidirectional flexible antenna so that the radiating element is elevated above the cameraman’s head. 3. In some transmitte...
Page 4
3 pac-2g3 clip-on power amplifier user’s manual main index 1 description ................................................................................. 4 2 technical features ..................................................................... 5 2.1 main characteristics ............................
Page 5
4 pac-2g3 clip-on power amplifier user’s manual 1 description the new pac-2g3 is a clip-on amplifier which works in the 2ghz band. It is used together with svp broadcast microwave’s camera transmitters, allowing the coverage of wider areas. It can be used with neatly all camera transmitters as it ca...
Page 6
5 pac-2g3 clip-on power amplifier user’s manual 2 technical features 2.1 main characteristics frequency range: 2,0 to 2,5 ghz (other frequency bands upon request) output power: pac-2g3: 1 or 3 watt (selectable) pac-3g3: 0.5 or 1 watt (selectable) input level: 10 to 100 mwatt (10 to 20 dbm) alc: 10 d...
Page 7
6 pac-2g3 clip-on power amplifier user’s manual the following figures show the pac-2g3 front and rear panels. Connections mentioned in the upper figure are shown below. Figure 2.2 front panel of the pac-2g3 amplifier figure 2.3 rear panel of the pac-2g3 amplifier technical features of each connectio...
Page 8
7 pac-2g3 clip-on power amplifier user’s manual table 2.1 power supply connection technical features item features connector label power d.C. Connector type 4 pin lemo 1b input voltage range 11-28 v. Consumption 3 watt: 2,9a @ 12v 1,4a @ 24v 1 watt: 2,0a @ 12v 1,0a @ 24v the pin-out of the power sup...
Page 9
8 pac-2g3 clip-on power amplifier user’s manual table 2.3 rf output characteristics item features connector label rf out output frequency range 2,0 to 2,5 ghz (other frequency bands upon request) connector type n female impedance 50Ω output power pac-2g3: 1 or 3 watt pac-3g3: 0.5 or 1 watt.
Page 10
9 pac-2g3 clip-on power amplifier user’s manual 3 amplifier operation tips this third chapter provides the user with all necessary information to operate the equipment properly. 1. If the amplifier will be powered by a battery, make sure that you have the right battery for the equipment to operate. ...
Page 11
10 pac-2g3 clip-on power amplifier user’s manual notes:.
Page 12: Final Note
11 pac-2g3 clip-on power amplifier user’s manual final note svp broadcast microwave s.L. Is constantly striving to improve all of its products. Therefore, we ask you to understand that modifications may occur in designs, equipment and technology. Consequently, no responsibility can be derived from t...
Page 13
Svp broadcast microwave reserves the right to make changes to this manual and to the equipment without prior notice. Svp broadcast microwave c/ zubiaurre 7 bajo 48215 iurreta vizcaya – españa tel: (+34) 94620 3722 info@svpbm.Com www.Svpbm.Com.