SVP CLIP ON PAC-2G3 User Manual - page 10
9
PAC-2G3 Clip-On Power Amplifier
User’s Manual
3 Amplifier Operation Tips
This third chapter provides the user with all necessary information to
operate the equipment properly.
1. If the amplifier will be powered by a battery, make sure that you have
the right battery for the equipment to operate.
2. If the amplifier will be powered through the DC IN connector. Check the
continuous voltage range and use the appropriate cable. The range of
the continuous voltage is the following one: 11 to 28 V.
3. When powering the equipment using the DC connector, be particularly
careful of the continuous power’s polarity. The power amplifier is
protected against reverse polarity.
4. Configure the output power of the transmitter. Set the output power in
Low mode.
5. Before you connect the amplifier, check that the antenna, cables and
connectors are in perfect condition. Do not switch on the device if the
antenna is not connected.
6. For the use of this amplifier together with wireless camera transmitter it
is recommended that flexible long antennas are used, for example: AVF-
203LB this way the radiation element of the antenna is over the
cameraman’s head.