SVT 3100 User manual - page 6
-5-
In the setting mode:
Press 1. Di sound indicates it is in the adding user card mode.
Enter the last 6-digits of a new card number. If Di sound is heard,
it indicates the adding is successful. Or swipe the new card
instead of adding the card numbers. If a Di sound and another Di
sound are heard, it indicates the adding is successful.
Continuous batch adding new user cards is available. If a
registered card is added, four Di Di Di Di rejection sounds will be
heard. It indicates this card has been registered.
Press * to return to setting mode. Then press * to return to standby
mode. No operation in 30 seconds will return automatically.
Use master card to add user card:
In the standby status, swipe master card once. A Di sound
indicates it is in the adding card mode.
During the adding card mode, swipe each new card will
accomplish with a Di sound. Another Di sound to confirm that the
setting is successful. Registered card will be rejected. After four Di
sounds, swipe master card again to return to standby mode.
Add user card
In the setting mode:
Press 2 with a Di sound. It is in the delete card mode. Enter the
last 6-digits of the card to be deleted. If a Di sound is heard, it
indicates the deletion is successful. Or swipe the card to be
deleted, if a Di sound is heard, and another Di sound indicates
deletion is successful. Continuous batch deleting user cards is
available. If deleted card is deleted again, the access control will
sound four Di rejection sounds. It indicates this card has been
deleted.
Press * to return to setting mode, and press * again to return to the
standby mode. No operation in 30 seconds will return automatically.
Delete user card
Delete all user cards
In the setting mode:
Press 9 with a Di sound heard. And then press 9, continued short
Di sounds can be heard. After it stops, it indicates the deletion of
all user cards is successful.
Press * to return to standby mode. No operation in 30 seconds will
return automatically.