SW SHS050W User Manual - Attention:

6.  Installation of SHS050

After disconnecting the packing, please read this manual carefully and 

operate the system according to the instruction. It is good for extending 

the life of equipment, especially the battery. At the same time, 

it can also lessen some unnecessary loss. 

6.1 Check the equipments and accessories

1) Check and amount all the accessories of FS-SHS50W to confirm 

whether they are all right. (Refer to the products list) 

2) Whether all the accessories are in good condition. In the 

transportation there may be some broken components, If these 

components are used in the system, it may affect the system. 

6.2 Installation and connection of system

6.2.1 Installation of bracket and solar panels 

Bracket is made up of two parts: pole and tray. 

Installing step: 

1) Tamp the pole into the ground   

2) Insert the tray on the top of pole and rivet it with screw. 

3) Rivet the panel on the bracket with screw.   

Attention:  

● The azimuth angle of the bracket bottom should be just south. The obliquity of the 

solar module is 60° ;( in accordance with local latitude) 

● Because of the heavy wind, each junction should be connected hard. 

● It is not allowed to sustain other objects with the bracket. It is also not allowed to 

climb the bracket. 

6.2.2 Placement of power box 

Except for the special protector, it is not allowed to put the power box 

outside.  

Attention: 

● It is not allowed to put power box in the environment with combustible gas; 

● Power box must be put in dry environment; 

● It should be put far away from water; 

● be sure that animals and children can not touch it;