SW SHS050W User Manual - 2. Specifications
1.5 PREPARING TO CHARGE
a) Never charge a frozen battery.
b) Be sure battery is mounted in a well ventilated compartment.
1.6 CHARGER LOCATION & INSTALLATION
a) Controller employs components that tend to produce arcs or sparks. NEVER install in
battery compartment or in the presence of explosive gases.
b) Protect all wiring from physical damage, vibration and excessive heat.
c) Insure that the controller is properly setup for the battery being charged.
d) Do not expose controller to rain or snow.
e) Insure all terminating connections are clean and tight to prevent arcing and overheating.
f) Charging system must be properly installed as described in these instructions prior to
operation.
g) Do not connect to a PV array capable of producing greater than 24 amps of short circuit
current @ 25 °C.
1.7 Use the scope
This SHS050 is applicable to the family usually power supply, such as the saving lamp, the
direct current radio the small power of etc. solar cell outside, other equipments( such as:
Power box, battery) under the condition of have no protection measure, can install only
indoors.
2. Specifications
2.1 General Specifications
Product name: FS-SHS50W
Product Description: Solar Home System
Products list of the solar home system
Item
Name
specification
QTY
1 Solar Module (50Wp±5%)
18V,50Wp
1
2 Solar Panel Mounting Frame (Pole)
2.5m
1
3 Battery (Sealed Lead Acid)
12V/65Ah
1
4 Battery and Power supply box
430*220*320mm
1
5 Charge Controller for Solar PV
12V/6A
1
6 Compact
Fluorescent
Lamps (CFL)
12V/11W
1
7 Cable of Lamp
5m*2.5mm2
1
8 Cable of solar module
15m*2.5mm2
1
9 User
Manual
1