SW-Stahl S3201 Instruction Manual - page 11
SW-Stahl und Werkzeugvertriebs GmbH
Tel. +49 (0) 2191 / 46438-0
www.swstahl.de
Leverkuser Straße 65
Fax +49 (0) 2191 / 46438-40
D-42897 Remscheid
E-Mail: info@swstahl.de
- 11 –
SPECIFICATIONS
Model: S3201
- 11 -
MAINTENANCE
Maintenance of the DC motor. Exercise due
care to ensure the motor does not burn out due
to overloading.
Do not allow brake-fluids, gasoline, petroleum-
based products, penetrating oils, etc. to come
in contact with plastic
parts.
They
contain
chemicals that can damage, weaken or destroy
the tool and battery housing.
Repairs should only be done by a qualified
service technician using identical parts to
ensure the safe and effective use of this
product.
Always ensure that the machine is switched off
and the battery cartridge is removed before
carrying out any work on the machine.
To maintain product safety and reliability,
repairs, maintenance or adjustment should be
carried out by an authorized service center.
Lubrication
All of the bearings in this tool are lubricated with
a sufficient amount of high grade lubricant for use
under normal conditions before leaving the
factory. Regular addition or replacement of the
lubricating grease is not necessary. However, on
occasions when new or more lubricant is needed,
take the tool to a qualified technician to do the
job.
NOTE: Do not use oil as a grease substitute. It
will leak and degrade the performance of this
product.
ACCESSORIES
All accessories designed for this tool is included
with this product. Storage spaces for sockets and
extension bar are provided in the carrying case
for your convenience. Sockets and extension bar
can be obtained through your local retailers. If the
retailer does not have the parts you need, simply
contact the authorized dealers for instruction on
how to order. Be sure to have ready the model
number of the product.
Voltage:
Chuck Capacity:
No-load Speed:
Impact per minute:
Max Torque:
Tool Weight:
(without battery)
Battery Weight:
(Ni-MH/ 2.0Ah)
(Li-ion/ 3.0Ah)
Length:
Charge Time:
Charger accepted:
14.4 VDC
6,35 mm (1/4“) inner hexagon
0 ~ 2,300 rpm
0 ~ 3,000 rpm
100 ft-lbs (136 N-m)
2.4 lbs (1.1 kgs)
1.9 lbs (0.85 kgs)
1.3 lbs (0.6 kgs)
6.9“ (176 mm)
approx. 60 mins
Ni-MH/ Li-ion