SW-Stahl S3201 Instruction Manual - page 3
SW-Stahl und Werkzeugvertriebs GmbH
Tel. +49 (0) 2191 / 46438-0
www.swstahl.de
Leverkuser Straße 65
Fax +49 (0) 2191 / 46438-40
D-42897 Remscheid
E-Mail: info@swstahl.de
WARNING! READ ALL INSTRUCTIONS
Always observe the safety regulations applicable in your country to reduce the risk of
fire, electric shock and personal injury. Understand the following safety instructions
before attempting to operate this product. Always wear eye protection when working
with power tools. Keep these instructions in a safe place.
SAVE THESE INSTRUCTIONS
General Safety Rules
Work Area Safety
Personal Safety
- 3 -
Keep your work area clean and well lit.
Cluttered benches and dark areas invite
accidents.
Do
not
operate
power tools in
explosive atmospheres, such as in the
presence of flammable liquids, gases,
or dust. Power tools create sparks which
may ignite the dust or fumes.
Keep bystanders, children, and visitors
away while operating a power tool.
Distractions can cause you to lose control.
Stay alert, watch what you are doing
and
use
common
sense
when
operating a power tool. Do not use tool
while tired or under the influence of
drugs,
alcohol,
or
medication.
A
moment of inattention while operating
power tools may result in serious personal
injury.
Dress properly. Do not wear loose
clothing or jewelry. Contain long hair.
Keep your hair, clothing, and gloves
away from moving parts. Loose clothes,
jewelry, or long hair can be caught in
moving parts.
Do not overreach. Keep proper footing
and balance at all times. Proper footing
and balance enables better control on the
tool in unexpected situations.
Use safety equipment. Always wear
eye protection. Dust mask, non-skid
safety shoes, hard hat, or hearing
protection must be used for appropriate
conditions.
Tool Use and Care
Use clamps or other practical ways to
secure and support the work piece to a
stable platform. Holding the work piece
by hand or against your body is unstable
and may lead to loss of control.
Do not force tools. Use the correct tool
for your application. The correct tool will
do the job better and safer at the rate for
which it is designed.
Do not use tool if switch does not turn
it on or off. Any tool that cannot be
controlled with the switch is dangerous
and must be repaired.
Store idle tools out of reach of children
and other untrained persons. Tools are
dangerous in the hands of untrained
users.
Check for misalignment or binding of
moving parts, breakage of parts, and
any other condition that may affect the
tool operation. If damaged, have the
tool serviced before using. Many
accidents
are
caused
by
poorly
maintained tools.