Swagelok TUBE FACING TOOL User Manual - page 16
– 13 –
Figure-28
Special Adjustment Features
Fixture Set Screw
There is a set screw located in the top of the hinge
of the fixture
(See Figure-28).
This screw should
only require use if you experience problems
securing the tubing. If the tubing is undersized and
rotates in the collet, the set screw can be turned
clockwise. If the tubing is oversized and the latch
will not secure the tubing, the set screw can be
turned counter-clockwise. If you are still unable
to secure the tubing properly after making these
adjustments, then the tubing is outside of the size
range for the collets.
Motor/Housing Set Screw
There is a set screw located in the underside of the
facing tool housing
(See Figure-29).
The set screw
should only be used if the motor and housing are
separated, such as if the motor were to be replaced.
An adjustment to this set screw may be needed if
there is a change to the orientation of the motor
handle and spindle feed handle. This set screw
provides a centering adjustment between the motor
and the housing.
Figure-29
Set
Screw
Hinge
Housing
Set Screw