1. DL manuals
  2. T.a.c.
  3. Temperature Controller
  4. TS-57011-770 850 Series
  5. General Instructions Manual

T.a.c. TS-57011-770 850 Series General Instructions Manual

Manual is about: Electronic Room Temperature Sensors

Summary of TS-57011-770 850 Series

  • Page 1

    Printed in u.S.A. 8-06 © copyright 2006 tac all rights reserved. F-23837-5 tac 1354 clifford avenue p. O. Box 2940 loves park, il 61132-2940 www.Tac.Com application these sensors provide electronic sensing of room temperature at wall locations for use with microprocessor-based energy management syst...

  • Page 2

    2 © copyright 2006 tac all rights reserved. F-23837-5 specifications sensor inputs connections: coded screw terminals. Environment ambient temperature limits: shipping, -40 to 160°f (-40 to 71°c). Operating, 40 to 140°f (4 to 60°c). Humidity: 5 to 95% rh, non-condensing. Locations: nema type 1. Opti...

  • Page 3

    F-23837-5 © copyright 2006 tac all rights reserved. 3 table-1 specifications. Table-2 temperature vs. Resistance. Typical application part number cover thermometer cover dimensions h x w x d in. (mm) temperature sensing element range display description brand name resistance maximum error over 100°f...

  • Page 4

    4 © copyright 2006 tac all rights reserved. F-23837-5 installation inspection inspect the package for damage. If damaged, notify the appropriate carrier immediately. If undamaged, open the package and inspect the device for obvious damage. Return damaged products. Requirements • job wiring diagrams ...

  • Page 5

    F-23837-5 © copyright 2006 tac all rights reserved. 5 mounting dimensions figure-2 dimensions for mounting ts-5711-770 and ts-5711-850 series on american standard 2" x 4" electrical box. 1-7/16 (37) depth = 1-5/8 (43) dimensions shown are in inches (mm). 1-5/8 (43) 4-7/16 (113) 3-9/32 (83) centered ...

  • Page 6

    6 © copyright 2006 tac all rights reserved. F-23837-5 mounting ts-5711-770 and ts-5711-850 sensor on american standard 2" x 4" electrical box 1. Remove the cover screw and remove the sensor cover from the base plate (see figure- 6 ). 2. Identify the two wires that are to be connected to the sensor. ...

  • Page 7

    F-23837-5 © copyright 2006 tac all rights reserved. 7 mounting ts-57011-770 or ts-57011-850 series sensor on american standard 2" x 4" electrical box 1. Remove the sensor cover from the base plate, according to the following: a. Insert the blade of a small-bladed screwdriver into the cover latch slo...

  • Page 8

    8 © copyright 2006 tac all rights reserved. F-23837-5 6. Connect the wires to the terminal block on the base plate. See the wiring diagrams in figure-1 . When installing a wire in the terminal block, insert the wire from the top side of the terminal and secure it by tightening the screw located on t...

  • Page 9

    F-23837-5 © copyright 2006 tac all rights reserved. 9 mounting ts-57011-770 or ts-57011-850 series sensor on european 1/4 din standard electrical box 1. Remove the sensor cover from the base plate, according to the following: a. Insert the blade of a small-bladed screwdriver into the cover latch slo...

  • Page 10

    10 © copyright 2006 tac all rights reserved. F-23837-5 5. Using two appropriately sized mounting screws (not provided), mount the base plate onto the 1/4 din electrical box. Note: no more than 6" (152 mm) of wire should remain under the cover. 6. Strip 1/4" (6 mm) of insulation from the ends of the ...

  • Page 11

    F-23837-5 © copyright 2006 tac all rights reserved. 11 mullion mounting ts-57031 and ts-57031-850 1. Using a 0.062" allen wrench (tool number n2-4), turn the cover set screw clockwise into the base plate, to release the sensor cover. Remove the sensor cover. Refer to figure- 11 . Note: the sensor is...

  • Page 12

    Copyright 2006, tac all brand names, trademarks and registered trademarks are the property of their respective owners. Information contained within this document is subject to change without notice. F-23837-5 www.Tac.Com tac 1354 clifford avenue p.O. Box 2940 loves park, il 61132-2940 wiring caution...