T+A K8 User Manual - page 7
The power supply features a low radia-
tion heavy-duty toroidal mains trans-
former with huge reserves even under
heavy load. All stages and voltages have
an elaborate individual regulation. Due
to a separate start-up transformer the
power consumption is below 1 watt in
standby mode.
The housing has a two-part construc-
tion. Located inside is the supporting
steel tray, on the outside are the fi ne
decorative parts made from solid alumi-
nium. Owing to the screw joints and its
heaviness the K8 is completely decoupled
from the environment.
The design of the T+A switching power
amps: modulator, dual MOSFET and a
massive heatsink. The seven power am-
plifi ers sound brillant, command huge
reserves and have proven to be extremely
rugged high performance tools.
Power amp out with sophisticated fi ltering,
high-quality chokes and processor-
controlled protection circuit for all
operating conditions. The gold-plated
pure brass loudspeaker terminals are
directly connected.
The smart-controlled cooling fan keeps
the internal temperature constant and
remains silent even under heavy load.
The air stream flows from the front
underside across the device and escapes
through the rear cooling slots.
The steel chassis tray is the backbone
of the K8. Not only does it ensure the
high rigidity of the whole construction,
but also the easy accessibility of the
individual boards. There is an upper
compartment for the signal processing
boards and a lower one for the power
amplifi ers and the power supplies.