T+A PH 2000 Operating Instructions Manual - page 4
4
Inbetriebnahme
Der Phonovorverstärker PH 2000 ist entweder mit MC-Modul
(für dynamische Tonabnehmersysteme) oder mit einem MM-
Modul (für magnetische Tonabnehmersysteme) ausgestattet.
Durch Kauf des nicht eingebauten Moduls kann der PH 2000
auch nachträglich auf MC bzw. MM umgerüstet werden.
Von entscheidender Bedeutung für die Klangqualität eines
Tonabnehmersystems ist die genaue Anpassung. Deshalb
kann der PH 2000 durch interne Codierschalter perfekt an
alle gängigen Tonabnehmersysteme angepasst werden -
siehe dazu Tabelle 1 und Tabelle 2.
Werkseitige Anpassung
MC-Modul
Eingangsempfindlichkeit:
250 µV
Eingangsimpedanz:
100 Ω
MM-Modul
Eingangsempfindlichkeit:
2 mV
Eingangskapazität:
120 pF
Using the PH 2000 for the first time
The PH 2000 phono pre-amplifier is equipped either with an
MC module (for dynamic pick-up systems) or an MM
module (for magnetic pick-up systems). You can purchase
the alternative module and use it to convert the pre-amplifier
from MC to MM and vice versa at any time.
The correct set-up is of vital importance to the sound quality
of any pick-up system. For this reason the PH 2000 features
a set of internal code switches which can be used to adjust
the unit to match all current pick-up systems - see Table 1
and Table 2.
Default set-up
MC module
Input sensitivity:
250 uV
Input impedance:
100 Ω
MM module
Input sensitivity:
2 mV
Input capacitance:
120 pF