T+A PH 2000 Operating Instructions Manual - page 7
7
Einstellen der Eingangsempfindlichkeit
Mit den Codier-Schaltern 'S2/S52' wird die gewünschte
Eingangsempfindlichkeit für den linken und rechten Kanal
gemäß Tabelle 1 eingestellt.
Die benötigten Daten entnehmen Sie den Herstellerangaben
des Tonabnehmersystems. Wählen Sie den Wert, der den
Herstellerangaben am nächsten liegt. Es müssen unbedingt
beide Kanäle gleich eingestellt werden!
Sollten Ihnen keine Herstellerangaben vorliegen, benutzen
Sie zunächst die Werkseinstellung
MC:
250 μV
MM:
2,0 mV
Hinweis: 1000 μV entspricht 1 mV
Setting the input sensitivity
The code switches 'S2/S52' are used to set the desired input
sensitivity for the left-hand and right-hand channels.
The information required for this setting should be included in
the Specification provided by the pick-up cartridge
manufacturer. Select the value which is closest to the
manufacturer’s stated figure. Be sure to select the same
setting for both channels!
If you do not have the manufacturer’s Specification, start with
the factory default settings:
MC:
250 μV
MM:
2,0 mV
Note: 1000 μV = 1 mV
Schalterstellung
Switch position
Eingangsempfindlichkeit
Input sensitivity
Eingangsempfindlichkeit (MM)
Input sensitivity (MM)
OFF
OFF
OFF
OFF
>
2000 μV
6mV
...
10,0mV
OFF
OFF
OFF
ON
1200 μV
...
2000 μV
3,5mV
...
6,0mV
OFF
OFF
ON
OFF
800 μV
...
1200 μV
2,5mV
...
3,5mV
OFF
OFF
ON
ON
600 μV
...
800 μV
OFF
ON
OFF
OFF
400 μV
...
600 μV
1,5mV
...
2,5mV
OFF
ON
ON
OFF
300 μV
...
400 μV
ON
OFF
OFF
OFF
200 μV
...
300 μV
1mV
...
1,5mV
ON
ON
OFF
OFF
160 μV
...
200 μV
ON
ON
ON
ON
100 μV
...
160 μV
Tabelle / Table 1