T+A TLW 2 A User Manual - page 21
21
Connecting the sub-woofer to a surround decoder
Wiring diagram 3
Switch / adjustor settings
No.
Purpose
No
control
voltage
Control
voltage
present
Automatic power-on
AUTO
AUTO
Control signal
CTRL
Filter
OFF
OFF
The settings of the switches / adjustors
,
,
and
can be changed as required.
The Cinch lead carrying the SUB OUT signal from the
surround decoder is connected to one of the sub-
woofer's CINCH IN sockets
.
Since the SUB OUT signal is filtered in the decoder, the
Filter switch
must be set to the 'OFF' position.
Use without control voltage:
The automatic power-on circuit is triggered by the
SUB OUT signal.
Use with control voltage (optional):
If the surround decoder features a control voltage output,
this control voltage is passed to the DIN IN socket
via
an adaptor lead. This triggers the automatic power-on
circuit.
The
DD 1210 R and DD 1510 R surround decoders
supply a control voltage at the 5.1 OUTPUT socket.
Connecting the sub-woofer to the
K6 DVD
surround receiver
Wiring diagram 4
Switch / adjustor settings
No.
Purpose
Control voltage
present
Automatic power-on
AUTO
Control signal
CTRL
Filter
OFF
The settings of the switches / adjustors
,
,
and
can be changed as required.
The sub-woofer output signal (SUBW) from the K6 is
passed to the DIN-IN socket
on the K6 via the AKS6
adaptor and the SC
LINK
lead.
Since the SUBW signal is filtered in the K6, the Filter
switch
must be set to the 'OFF' position.
The control signal is present at the CONTROL socket of
the K6. It reaches the DIN IN socket
by the same
route, and triggers the automatic power-on circuit.